Step-by-Step Instructions #

A. Go to Operations

• From the main dashboard, navigate to the Operations module.
• Select “Perform Bump Test” under the Bump Test card.

B. Select the gas detector to be bump tested.

• Use the search bar to find the gas detector on which you want to perform a bump test.
• Click the Record button on the right side of the instrument information to display the instrument status on the right side of the screen.
• Perform the bump test on the gas detector, then record the test result (Pass or Fail).
• You can record the test gas used for the bump test by using the cylinder lot number.
• Confirm that the bump test has been performed in accordance with the manufacturer’s instructions and recommendations, then click the Record Test button.

⚠️ NOTE : If the bump test passes, the instrument will become available for check-out.

⚠️ NOTE : If the bump test fails, the instrument status will switch to maintenance mode until a new calibration or maintenance activity confirms that the instrument is in good working condition.